Peerless Universal Tilt Wall Mount for 37"- 60" Flat Panel Screen with one Touch Tilt
The ST660 delivers enhanced screen compatibility, accommodating large flat panel screens including those with VESAŽ 800 x 400 mm hole pattern. Its open wall plate architecture delivers placement flexibility and increased electrical and cable management access. Unique pre-tensioned universal tilt screen adapters provide one-touch tilt viewing angle adjustment completing the perfect flat panel installation.
Peerless Universal Tilt Wall Mount for 37"- 60" Flat Panel Screen with one Touch Tilt Accessories
 Cables To Go - 40315 - 2M (6.5ft) Velocity HDMI Digital Video Cable (Blue)
Samsung LN52A650 52-Inch 1080p 120Hz LCD HDTV with Red Touch of Color
HDMI Cable 2M (6 Feet)
Samsung LN52A750 52-Inch 1080p DLNA LCD HDTV with RED Touch of Color
Samsung FPT5084 50-Inch 1080p Plasma HDTV
Samsung LN52A550 52-Inch 1080p LCD HDTV
Samsung LNT5271F 52-Inch 1080p 120Hz LCD HDTV
Samsung BD-P1500 1080p Blu-ray Player
Sharp Aquos LC52D64U 52-Inch 1080p LCD HDTV
Cables Unlimited 6-Foot HDMI Male to Male Cable (PCM-2295-06)
Peerless Universal Tilt Wall Mount for 37"- 60" Flat Panel Screen with one Touch Tilt Reviews
This is excellent designed,the instructions were very clear and this was very easy to install.
The tv is a 52" and adding the wall mount was very easy. I researched alot of wall mounts from the big electronics stores and they were way over priced. This unit is very strong. Well if you are looking for a reasonable price wall that is very strong this is the one.
(It is one-touch after taking the time to unlock the nuts on both sides). My husband installed this mount himself in about an hour for our 52" Samsung. We have a solid wood wall behind it, so no having to search for studs. Take the time to read the directions, use a level, measure twice and drill once; you will not be disappointed :-) The one-touch tilt is great and you lock your angle choice in so it doesn't "droop" out of position. It has plenty of room though for proper positioning of our size tv to accomodate variance in stud distances. I loved paying about $250 less than Best Buy's "value" mount.
Mount is solid and recommended. Only problem I had was the Sony rear had left side bracket screw holes shorter than the right side bracket screw holes. Instructions were good, item solid. So I used the provided screws to attach the right side, but went to Home Depot to get 2 shorter screws for the left side. So far, it looks terrific. Installed our 52" Sony KDL-52W3000 LCD screen over our fireplace with this mount. Enough screws to do the job.
Works fine otherwise. I bought this wall mount over others because it can be tilted upwards 5 degrees, allowing easier access to cables on the back of the TV. The hand-tightened screws which allow setting the tilt angle are not adequate for my 50" plasma the TV tilt angle slowly drops down to face the floor (greater than 20 degrees tilt). However, inserting the required screws in one of the 5 degree increments with the special hex tool is next to impossible. Thus, you must use a special hex tool supplied with the mount to set the tilt angle in fixed 5 degree increments. You're better off just calling the neighbor and lifting the TV off the wall, make your cable changes, and lift it back up on the wall again.
|
